Protect-a-Pipe (Specialising in fire protection installation); with years of experience the director of Protect-a-Pipe recognised an area that required improvement in relation to the Fire Protection of support hangers within the industry. Protect-a-Pipe has designed, tested and certified products to meet the fire rated standards in accordance with AS 1530.4.

Protect-a-Pipe has developed a solution to provide quality service and quality product, over the last 24 months we have been working hard to improve the method in applying the fire rated product by the use of moulds. As you will see in the photos below we apply the fire rated product typically like others, the only difference is – now visually appealing with nominated specific wall thicknesses and density controls based on the supplier’s guidelines which meet the standards.

  • 2016

     

    Brainstorming Commenced

    With years of experience in the Fire Protection Industry, in 2016 we recognised an area that required improvement in relation to the fire protection of support hangers within the industry.

  • 2016 - 2017

    Design Phase

    Progressively designed and tested prototypes to comply with the standards in accordance with AS1530.4

     

    2016 - 2017

  • 2017

     

    Product Development

    We began fabrication of mild steel moulds – removable. We started lasercut flat pack mild steel moulds, with tabs for assembly – non removable. Finally developed the lasercut flat pack 304 Stainless Steel moulds, with 304S/S screws – non removable moulds for added protection and visually appealing.

  • 2018

    Protect-A-Pipe Was Born

    Ready for market, we offer 8 specially designed moulds which offered as flat pack system or assembled, if you have a special request we can custom design to suit your requirements using the same design criteria’s

     

    2018

Full Exova Report

(Click Image for Download)

Full Intertek Test Report

(Click Image for Download)

© Copyright - Protect A Pipe 2018